Ayville Engineering Company (MEC) heavy equipment has been used to produce a new round of shotgun ammunition. They shotshell Press Feeders equipped with a rotating shell holder "tree" of multi-station, which allows you to quickly reload a lot of shotshells installed under. MEC shotshell presses ship dismantling facility. Must be fitted to one of the main news frame components is cited feeder automatically provided for each new primer Reporters mechanism shotshell. MEC production of eight reporters models are all similar primer feed installation.Explain 1 Make sure to install the required components. The Press Feeders are included in the bag of parts, ship and your MEC reloader. You will need a primer feed tray, clip Yinchun / chain and primer feed. 2 Inserted into the clip within the primer feed tube clamp mounted directly on the location of the suction station in front. On the primer tray into the feed tube, pipe wrench. 3 Press operating handle to push down on to the shell holder until it contacts the bottom of the suction station. Adjustment of the introduction of the feed tube, the primer hole is so that on the shell holders. The position held by the introduction of the feed pipe wrench to tighten the screws. 4 Additional Yinchun / chain slightly higher than the suction station rack installation hook on the end of the spring open. The spring clamp the other end of the feed tube. The free end of the introduction of the feed tube bracket clamp chain. 5 Test and adjust business reporters handle load it into the position of the tray a few primer chain. Each operating handle, pull the shell holders to put a new primer. The location of the chain can be adjusted to change specific aspects for the bracket attached to the feed tube. last,the Press Feeder has installed!